Terry, I just started HRD Ver 6+ It connected and read my radio's frequency and I could turn the dial and it followed my radio. I put in W1AW and it looked up the address fine.
Donn W0TK
Search found 7 matches
- 11 Sep 2018, 21:15
- Forum: User Support
- Topic: New user, no CAT control
- Replies: 15
- Views: 9352
- 11 Sep 2018, 21:07
- Forum: User Support
- Topic: New user, no CAT control
- Replies: 15
- Views: 9352
Re: New user, no CAT control
I can try connecting to HRD I have only 3 port connections.
Comm port 1
Intel port 3
Silicon Lab Port 6
Donn W0TK
Comm port 1
Intel port 3
Silicon Lab Port 6
Donn W0TK
- 11 Sep 2018, 21:05
- Forum: User Support
- Topic: New user, no CAT control
- Replies: 15
- Views: 9352
Re: New user, no CAT control
Remember I can click on a spot and it fills the CALLSIGN and looks up if we have worked before. I can tab throng and log the call. Just no frequency or mode or report.Yesterday I worked a guy and uploaded and downloaded info from LOTW Donn W0TK
- 11 Sep 2018, 20:57
- Forum: User Support
- Topic: New user, no CAT control
- Replies: 15
- Views: 9352
Re: New user, no CAT control
Terry, I have not changed the computers drivers. It has been functioning for 3 years with HRDeluxe and this radio for a year and before 2 years with the Non SG model. I have double checked every radio setting after return from service. I wanted to try Log4om because I was fed up with HRDeluxe after ...
- 11 Sep 2018, 20:29
- Forum: User Support
- Topic: New user, no CAT control
- Replies: 15
- Views: 9352
Re: New user, no CAT control
Terry, the radio is just back from service and a complete checkout. The drivers are already installed by Kenwood. These were the Silicon Lab drivers from when I first bought the rig. Can I try to uninstall Omnirig and then reinstall as an administrator? May help? I do have Teamview installed but ...
- 11 Sep 2018, 20:04
- Forum: User Support
- Topic: New user, no CAT control
- Replies: 15
- Views: 9352
Re: New user, no CAT control
Thanks for the fast reply. I have set Log4om to run as and administrator.
I have downloaded Omnirig as an administrator.
I am using Com 6 the same as where the silicon lab is showing in Device manager.
9600 baud rate
I am using a direct USB connection to my Kenwiid TS-590SG
I have downloaded Omnirig as an administrator.
I am using Com 6 the same as where the silicon lab is showing in Device manager.
9600 baud rate
I am using a direct USB connection to my Kenwiid TS-590SG
- 11 Sep 2018, 19:32
- Forum: User Support
- Topic: New user, no CAT control
- Replies: 15
- Views: 9352
New user, no CAT control
I am a new user and have not been able to get CAT to even open, I have tried Hamlib and Omnirig no luck.
Iv'e searched the forums and tried fixes to similar problems with no luck. CAT status button stays RED
I can click on a cluster spot and it will populate the Callsign box and check for previous ...
Iv'e searched the forums and tried fixes to similar problems with no luck. CAT status button stays RED
I can click on a cluster spot and it will populate the Callsign box and check for previous ...