Search found 7 matches

by w0tk
11 Sep 2018, 21:15
Forum: User Support
Topic: New user, no CAT control
Replies: 15
Views: 7669

Re: New user, no CAT control

Terry, I just started HRD Ver 6+ It connected and read my radio's frequency and I could turn the dial and it followed my radio. I put in W1AW and it looked up the address fine.

Donn W0TK
by w0tk
11 Sep 2018, 21:07
Forum: User Support
Topic: New user, no CAT control
Replies: 15
Views: 7669

Re: New user, no CAT control

I can try connecting to HRD I have only 3 port connections.
Comm port 1
Intel port 3
Silicon Lab Port 6

Donn W0TK
by w0tk
11 Sep 2018, 21:05
Forum: User Support
Topic: New user, no CAT control
Replies: 15
Views: 7669

Re: New user, no CAT control

Remember I can click on a spot and it fills the CALLSIGN and looks up if we have worked before. I can tab throng and log the call. Just no frequency or mode or report.Yesterday I worked a guy and uploaded and downloaded info from LOTW Donn W0TK
by w0tk
11 Sep 2018, 20:57
Forum: User Support
Topic: New user, no CAT control
Replies: 15
Views: 7669

Re: New user, no CAT control

Terry, I have not changed the computers drivers. It has been functioning for 3 years with HRDeluxe and this radio for a year and before 2 years with the Non SG model. I have double checked every radio setting after return from service. I wanted to try Log4om because I was fed up with HRDeluxe after ...
by w0tk
11 Sep 2018, 20:29
Forum: User Support
Topic: New user, no CAT control
Replies: 15
Views: 7669

Re: New user, no CAT control

Terry, the radio is just back from service and a complete checkout. The drivers are already installed by Kenwood. These were the Silicon Lab drivers from when I first bought the rig. Can I try to uninstall Omnirig and then reinstall as an administrator? May help? I do have Teamview installed but tha...
by w0tk
11 Sep 2018, 20:04
Forum: User Support
Topic: New user, no CAT control
Replies: 15
Views: 7669

Re: New user, no CAT control

Thanks for the fast reply. I have set Log4om to run as and administrator.
I have downloaded Omnirig as an administrator.
I am using Com 6 the same as where the silicon lab is showing in Device manager.
9600 baud rate
I am using a direct USB connection to my Kenwiid TS-590SG
by w0tk
11 Sep 2018, 19:32
Forum: User Support
Topic: New user, no CAT control
Replies: 15
Views: 7669

New user, no CAT control

I am a new user and have not been able to get CAT to even open, I have tried Hamlib and Omnirig no luck. Iv'e searched the forums and tried fixes to similar problems with no luck. CAT status button stays RED I can click on a cluster spot and it will populate the Callsign box and check for previous q...