Hello
In Sat Mode under My Station there is RX Power available. What means RX Power ? Thank you

Hello, Yes, all settings are correct. I also started Omnirig and Log4OM2 2.4.0.0 as administrator. The only thing that happens when I start Log4OM2 is that the Yaesu FT-857D is switching from VFO A to VFO B and back again from time to time. I am not sure if the reason is that I am using a Yaesu FT-8...

Hello I have a Yaesu FT-857D and a Kenwood TS-480HX. The Kenwood CAT-Connection is working without any problems with Log4OM2. But the connection to the Yaesu FT-857D is not working with Log4OM2 2.4.0.0. With Hamradio Deluxe for example the transceiver CAT-control of the Yaesu FT-857D is working fine...

Hello I observed that when a callsign can not be found in qrz.com then the operator name and the grid locator is left blank although I already had a QSO with the same station earlier and the operator name and grid locator are captured in the log. Obviously log4OM2 is only taking information from ext...

Hello I use Log4OM2 for QO-100 QSO logging. Usually I have to set the RX Freq. to 0.000 and block it. Then I have to set the RX Band to 3cm and block it. Would it be possible to enter an offset for 10 GHz on the RX Freq. ? I am working with the Yaesu FT-857 on 432.700 simplex. Now it would be nice i...

Hello I observed that when a callsign can not be found in qrz.com then the operator name and the grid locator is left blank although I already had a QSO with the same station earlier and the operator name and grid locator are captured in the log. Obviously log4OM2 is only taking information from ext...