Dear Colleagues,
I would like to propose an idea.
Probably some of us has a linear amplifier, and some have a manual tuning.
We have a paper with the values for "Tune" and "Load"
What do you think about the possibility to have it displayed ?
According with the Band / QRG it will show the values for Tune and Load as image I enclose.
The way to enter the values is a kind of table with some values per band, and than depending the qrg value it shows the values for TUNE and LOAD.
I hope I have been clear about the idea.
Thanks for reading.
Displaying Values Tune/Load Linear
Displaying Values Tune/Load Linear
73 Manuel Fernando CT1BXX
- G4POP
- Log4OM Alpha Team
- Posts: 10815
- Joined: 21 Jan 2013, 14:55
- Location: Burnham on Crouch, Essex UK
Re: Displaying Values Tune/Load Linear
I use a manual antenna matching unit and the same applies for that, nice idea but perhaps a little smaller ot stacked because the Winkeyer button will be alongside the Rig select drop down
73 Terry G4POP
- IW3HMH
- Site Admin
- Posts: 2927
- Joined: 21 Jan 2013, 14:20
- Location: Quarto d'Altino - Venezia (ITA)
- Contact:
Re: Displaying Values Tune/Load Linear
Ok, Terry can you add this one to our Mantis?
Daniele Pistollato - IW3HMH