Page 1 of 1
Power Levels
Posted: 15 Jan 2019, 09:40
by g4cfp
Is there anyway of reading the power levels rather than having it fixed in the setup menu.
I use a Icom IC-7100 (50watts) and a Icom IC-7300 (100watts)
Cheers
Bill G4CFP
Re: Power Levels
Posted: 15 Jan 2019, 09:46
by G4POP
I don't believe that either Omnirig or Hamlib provide commands to read the TX power level but I will check!
Re: Power Levels
Posted: 16 Jan 2019, 08:40
by G4POP
G4POP wrote: ↑15 Jan 2019, 09:46
I don't believe that either Omnirig or Hamlib provide commands to read the TX power level but I will check!
I have now checked the Omnirig commands and find that Omnirig do not provide a way of reading the TX power level set on the radio or any way of setting the power levels from Omnirig.
I specifically checked the Icom radios IC7000, 7100, 7300, 7600, 7700 and 7800
I suspect Hamlib may provide this feature because FLRig has a PWR level control and I beleive that uses Hamlib