When I "Send Command" it appears to go only to the server marked as PRI. Is it possible to send commands to all the connected servers or send commands to selected servers individually?
Mike
Cluster Commands
Re: Cluster Commands
Mike,
Did you tic the "Send to all servers" box?
I'm pretty sure I've seen conversation about this on the V2 Forum and wonder why you would want to send to "all" servers? Most all the servers are interconnected and sending to your prime server (I typically use VE7CC-23) will usually populate through all the servers.
- Attachments
-
- V2-SendToServers.JPG (81.83 KiB) Viewed 1530 times
73 - Nolan Kienitz - KI5IO
Plano, TX
Plano, TX
Re: Cluster Commands
Dang. Missed that thank you it works.
I don't think that the commands are relayed between servers, even if the servers are linked. (I really don't know much about how the system works). I want to do things like set my filters the same on all the servers I'm attached to.
I don't think that the commands are relayed between servers, even if the servers are linked. (I really don't know much about how the system works). I want to do things like set my filters the same on all the servers I'm attached to.