V2 Wrong Frequency report to QRZ

[HB9VQQ]

That’s not how QRZ works because it works fine with version 1 of LOG4OM and is not working with version 2. I just went back to using version 1 till the problem is resolved.

Can you show where QRZ.com shows Hz resolution ?

All I see is rounded to kHz

Unbenannt.JPG (74.75 KiB) Viewed 4066 times

again

That is how QRZ.com Log works. Resolution set to kHz, won't show Hz.

[W5RDL]

I guess the original issue was miss understood. When I log a contact with say 14.255 in LOG4OM in version 1 it’s received in QRZ as 14.255
Now when I’m using the same frequency in LOG4OM Version 2 it’s received in QRZ as 14.250 so hows it QRZ’s fault for this error.
Don’t get me wrong I love LOG4OM over all other logging problems. I was just pointing out a small error in frequency being seen or received in QRZ with the new Version 2.

[HB9VQQ]

Ok got it , I think there is another thread with the same issue

https://forum.log4om.com/viewtopic.php?f=31&t=4602

[g0ddj]

That’s not how QRZ works because it works fine with version 1 of LOG4OM and is not working with version 2. I just went back to using version 1 till the problem is resolved.

Nether of you answered my question "does it happen all the time" like every qso

Yes it is happening all the time with every contact. no problem with V1 though on QRZ.com

[HB9VQQ]

Trying to identifiy the root cause of this issue.

Logged in Log4OM like this

Unbenannt.JPG (14.91 KiB) Viewed 4031 times

That's the log on QRZ.com

Unbenannt1.JPG (12.5 KiB) Viewed 4031 times

Just for a test I deleted this QSO with TK5MH from QRZ.com which initially was uploaded automatically from Log4OM.
Then I manually exported just this QSO from Log4OM to an ADIF file. Content looks ok, frequency is still correct

...<FREQ:5>14.085....

Then I manually imported this ADIF file on QRZ.com, again showing the wrong frequency.

Unbenannt1.JPG (12.5 KiB) Viewed 4031 times

After that I imported the same ADIF file into HRD Logbook, showing wrong frequency.

Unbenannt2.JPG (16.02 KiB) Viewed 4030 times

73
Roland

[HB9VQQ]

After some research I found changing the Log4OM generated ADIF file from

<FREQ:5>14.085

to

<FREQ:6>14.085

and importing the file on QRZ.com the frequency is correct

Unbenannt.JPG (12.74 KiB) Viewed 4026 times

Each ADIF record contains one or more fields in the form of <keyword:n>value, where n is the number of characters in the data value. So a value of 5 is wrong and would represent 14.08. N needs to be 6.

If you are going to log VHF/UHF freq. it needs to be 7 and so on....

73
Roland

[g0ddj]

Nice to see that this problem has been resolved, thanks.