I programmed 2 receivers in Omnirig
When i active the CAT of the first receiver in log4om, all is ok
But impossible to active the CAT of the second receiver in log4om
Is it normal?
LOG4OM and OMNIRIG problem
- DF5WW
- Log4OM Alpha Team
- Posts: 2035
- Joined: 02 May 2013, 09:49
- Location: Kraam, Rhineland Palatinate, Germany
- Contact:
Re: LOG4OM and OMNIRIG problem
No, i have 2 transceivers running and all is fine. Did you run Log4OM and Omnirig and/or other
related softwares as administrator as described in the user manual ? Have you different COM
ports for those 2 receivers ? If a COM is used by Omnirig1 it can´t be used for Omnirig2.
related softwares as administrator as described in the user manual ? Have you different COM
ports for those 2 receivers ? If a COM is used by Omnirig1 it can´t be used for Omnirig2.
73´s .. Juergen ... ALT-512 SDR (10W) , 50 m random wire at SG-211 autotuner, 2 x Xiegu G90 (20W HF TRX) one as portable Radio. Also TS-790E (40 W) for VHF/UHF with X-50 vertical and Duoband 4-Element LPDA.
Re: LOG4OM and OMNIRIG problem
I also have 2 rigs connected to omnirig and I am using log4omv2. I can switch between rigs using Log4om. Make sure you are using 2 different com ports. I recently just upgraded to omnirig 1.19. User guide here is very helpful.
73,
Mike-W2MJP
Mike-W2MJP
Re: LOG4OM and OMNIRIG problem
Hi,
I work with Omni Rig with out problem. It works fie with JTDX and both Softwares have CAT
I had version 1.19 and I move back to 1.18 with better performance... With 1.19 I had some small cuts.
73 de Jose EC6DX
I work with Omni Rig with out problem. It works fie with JTDX and both Softwares have CAT
I had version 1.19 and I move back to 1.18 with better performance... With 1.19 I had some small cuts.
73 de Jose EC6DX
EC6DX Balearic Islands
Re: LOG4OM and OMNIRIG problem
Hello
What is better about 1.18? What do you mean by cuts? I am using 1.19 and I dont see any issues
73,
Mike-W2MJP
Mike-W2MJP
Re: LOG4OM and OMNIRIG problem
Hi...
I was using 1.19 and I changed to 1.18 because I loose conection sometimes... With V 1.18 all is better between JTDX and Log4OM
I can not explain why because I am a very poor technician... hihihi... It is my experience...
Log4OM works perfectly using Omni Rig with JTDX !!!
Jose
I was using 1.19 and I changed to 1.18 because I loose conection sometimes... With V 1.18 all is better between JTDX and Log4OM
I can not explain why because I am a very poor technician... hihihi... It is my experience...
Log4OM works perfectly using Omni Rig with JTDX !!!
Jose
EC6DX Balearic Islands