The propagation view in the main UI (F9) automatically follows the current operating band selection.
The same(?) window in the detached view ( View > Propagation ) requires manual band selection.
Propagation view band selection
- G4POP
- Log4OM Alpha Team
- Posts: 10808
- Joined: 21 Jan 2013, 14:55
- Location: Burnham on Crouch, Essex UK
Re: Propagation view band selection
Only if you open the window AFTER the call/band/mode lookup calculation has been done! Its already happened when you open the window!
Once the window is open ant further entries are automatically calculated
73 Terry G4POP
Re: Propagation view band selection
There seems to be an issue with that. See below.
I set myself up on 80 meters with both versions open, with WSJT-X feeding Log4OM. ("F9" on top, "View > Propagation below.)
As I worked different stations on 80m, both windows reflected the same information as expected..
Then I QSY'd from 80 to 40m.
The lower window ( "View > Propagation" ) did not follow, but stayed on 80m. Now when I work a new station, it does, in fact, recalculate. But provides 80m (not 40m) results.
Running v2.11.0.0 and Win10 PRO.
I set myself up on 80 meters with both versions open, with WSJT-X feeding Log4OM. ("F9" on top, "View > Propagation below.)
As I worked different stations on 80m, both windows reflected the same information as expected..
Then I QSY'd from 80 to 40m.
The lower window ( "View > Propagation" ) did not follow, but stayed on 80m. Now when I work a new station, it does, in fact, recalculate. But provides 80m (not 40m) results.
Running v2.11.0.0 and Win10 PRO.