Log4OM

I have a delay as I click on the DX spot radio switch over the time of 5-25 s.
I use omnirig . Other programs works fine.

Hello OM,

we have had no reported delay issues for the IC-7300 in the past.
Did you are using both programs with administrator rights ?

Are the settings in Omnirig are correct (e.G. Baudrate, Stopbits) ?

Only reported issue for the IC-7300 in the past was incorrect
switching to CW-R instead of CW but this can simply changed in
the IC-7300.ini file ...

Are you using Omnirig and if not you should do so.

Set Omnirig Poll int to 100

I'm using Omnirig, changing to administrator rights has not improved.
The bitrate is 19,200 because only the trx connection is set up just as the rest of the settings(bitstop etc) are correct as in other programs Loger32, JTDX, WSJTX- work properly.

sq7bcn wrote: ↑25 Sep 2017, 05:47 I'm using Omnirig, changing to administrator rights has not improved.
The bitrate is 19,200 because only the trx connection is set up just as the rest of the settings(bitstop etc) are correct as in other programs Loger32, JTDX, WSJTX- work properly.

Have you set Omnirig "Poll int ms" to 100?

I changed to 100ms - nothing improved .
Click on the spot and nothing happens sometimes after 30s interrupt, as it is on the same band it's faster

Send me a support request as detailed here http://www.log4om.com/log4om-support/ by email to g4pop (AT) arrl.net

Ok please email address ...

in my previous post or check out QRZ

sq7bcn wrote: ↑25 Sep 2017, 05:47 I'm using Omnirig, changing to administrator rights has not improved.
The bitrate is 19,200 because only the trx connection is set up just as the rest of the settings(bitstop etc) are correct as in other programs Loger32, JTDX, WSJTX- work properly.

You need to set your radio to 115.200 baud rate.