Page 1 of 1

Log4OM + VSPE + N1MM+

Posted: 24 Dec 2017, 07:53
by ON7CL
Hello FM,

I want to use the spectrum scope from N1MM+ on my IC-7300.
My Log4OM is running om com6 via omnirig.
When I make in VSPE a splitter from com 6 to com 8 the N1MM+ spectrum scope is working but the omnirig is not working anymore, the radio frequency is not popping up in the right corner of Log4OM and the radio is not following the Log4OM anymore when I make a band change.
Whats wrong ?

Thanks for reply and Merry Christmas.
Rudi / ON7CL

Re: Log4OM + VSPE + N1MM+

Posted: 24 Dec 2017, 09:09
by G4POP
Is Omnirig connected to the correct VSP Port?

Re: Log4OM + VSPE + N1MM+

Posted: 24 Dec 2017, 09:20
by ON7CL
Yes, and N1MM+ spectrum is working, but Log4OM not.

Re: Log4OM + VSPE + N1MM+

Posted: 24 Dec 2017, 09:37
by ON7CL
This what I see !

Re: Log4OM + VSPE + N1MM+

Posted: 24 Dec 2017, 10:45
by G4POP
Something is wrong with the VSP set up or perhaps the 7300 USB Silicon Labs CP210x UART Bridge drivers cannot be used with a VSP?

Try enquiring on the 7300 Yahoo group about this.

Sorry that we cannot help any further