Page 1 of 1

IC7300

Posted: 17 Sep 2018, 10:54
by G3UGK
Log4OM is working well with my IC7300 (Omnirig is set up correctly), with one exception. The drop down menu does not list the 7300 so the radio/log comms protocol is not quite correct. Which rig should I select from the list?

Phil

Re: IC7300

Posted: 17 Sep 2018, 11:04
by G4POP
Go to the Omnirig site and download the latest rig.ini file then copy it to the C:\Program files (X86)\Afreet\Omnirig\rigs folder

Then restart Log4OM and select the IC7300 file

Re: IC7300

Posted: 17 Sep 2018, 11:52
by G3UGK
Sorry Terry. I guess I didn't explain properly: Omnirig is working fine using the 7300.ini file. My issue is with the drop down list within Log4OM. Lots of Icoms listed there but no 7300. I'm sure I can select an alternative, but which one?
Phil

Re: IC7300

Posted: 17 Sep 2018, 12:07
by G4POP
You should see it in the Log4OM Omnirig window as below, perhaps its not in the correct folder?


Untitled.jpg
Untitled.jpg (43.1 KiB) Viewed 649 times

Re: IC7300

Posted: 17 Sep 2018, 12:23
by G3UGK
Yes, it is there and I'm using it. My problem is not with Omnirig but with Log40om There's a list of rigs within Log40om one of which has to be selected and there's no 7300 included in THAT list.

Phil

Re: IC7300

Posted: 17 Sep 2018, 13:31
by G4POP
Phil,
The screenshot I just posted is the Omnirig list from within Log4om

Are you sure that your not confused with the log4om Hamlib facility?

Post a screenshot please

Re: IC7300

Posted: 17 Sep 2018, 13:43
by G3UGK
Si it is. Can't imagine how I managed to get that up - must have been too quick on the mouse button. Thanks..

Part 2 then: When I select a station from the cluster the rig frequency changes OK, but not the mode. Is this correct?

Phil

Re: IC7300

Posted: 17 Sep 2018, 13:46
by G4POP
No it is not, both should change providing you have it set so to do in the options

Untitled.jpg
Untitled.jpg (183.79 KiB) Viewed 638 times

Re: IC7300

Posted: 17 Sep 2018, 15:22
by G3UGK
I think I'll go away and cry now... closely followed by a strong G&T

Thanks.

Phil

I might even download the instruction manual :)