log4om+pstrotator+ft847
Posted: 02 Oct 2018, 20:50
Just had another problem with log4om+ft847
If i run the software alone, no problem..
If i switch to satellite mode i can see vfoA and vfoB (which is reverse as i mentioned on previous post) but it is there.. And if i switch to normal vfo operation i can see tx/rx single window.. it works also
But if pstrotator is also connected to omnirig, switching vfo mode / sat mode does not change the freq display.. it still shows seperate vfoa/b with sat frequencies only.. it doesnt update the freq display to single vfo mode even if i disconnect pstrotator from omnirig.
It returns to normal only if i turn off log4om and turn it on again..
If i run the software alone, no problem..
If i switch to satellite mode i can see vfoA and vfoB (which is reverse as i mentioned on previous post) but it is there.. And if i switch to normal vfo operation i can see tx/rx single window.. it works also
But if pstrotator is also connected to omnirig, switching vfo mode / sat mode does not change the freq display.. it still shows seperate vfoa/b with sat frequencies only.. it doesnt update the freq display to single vfo mode even if i disconnect pstrotator from omnirig.
It returns to normal only if i turn off log4om and turn it on again..