when I am using the programmed channels in my Kenwood ts590 using Omnirig Log4OM does not see freq. But HDSDR using the same Omnirig does see the freq of rig ......this has been a problem in all versions
Thanks Greg W8OTR
Freq will not display
- VK7XX
- Old Man
- Posts: 437
- Joined: 24 Jan 2013, 04:07
- Location: Planet Earth on Tasmania Island
- Contact:
Re: Freq will not display
Greg, does the "CAT Status indicator at the bottom left side of the main Log4OM screen show as green ?? if not you have a setup problem somewhere. I am not familiar with the TS590 but for my Icom, in the 'Settings / Options' menu, on the tab 'Cat & Cluster' I have ticked in the box's for 'Omnirig' then 'Open CAT on program start' , CAT will set MODE when following spot' , CAT will switch to Digital...... maybe some of this will help. Happy New Yearw8otr wrote:when I am using the programmed channels in my Kenwood ts590 using Omnirig Log4OM does not see freq. But HDSDR using the same Omnirig does see the freq of rig ......this has been a problem in all versions
Thanks Greg W8OTR
John
VK7XX