I have noticed that if you edit a JT9 contact that has a plus signal strength report (eg +02) the signal report area (RST sent or RST recvd) gets blanked out. This does not happen if the report is a minus one (eg -02)
perhaps this could be fixed in the next release.
73
John
VK7XX
Report Field gets blanked out when editing a qso
- G4POP
- Log4OM Alpha Team
- Posts: 10815
- Joined: 21 Jan 2013, 14:55
- Location: Burnham on Crouch, Essex UK
Re: Report Field gets blanked out when editing a qso
Yes John that requires attention thank you
73 Terry G4POP
Re: Report Field gets blanked out when editing a qso
John, you should be able to resolve your issue by adding +01 to +25 to the "reportlistJT.txt" file to accommodate positive signal report values.
Bill WB9KPT
Bill WB9KPT
- IW3HMH
- Site Admin
- Posts: 2927
- Joined: 21 Jan 2013, 14:20
- Location: Quarto d'Altino - Venezia (ITA)
- Contact:
Re: Report Field gets blanked out when editing a qso
It's correct.
the value is blanked because, on load, it doesn't match with allowed RST report values.
Adding the + scale on next release
the value is blanked because, on load, it doesn't match with allowed RST report values.
Adding the + scale on next release
Daniele Pistollato - IW3HMH
- VK7XX
- Old Man
- Posts: 437
- Joined: 24 Jan 2013, 04:07
- Location: Planet Earth on Tasmania Island
- Contact:
Re: Report Field gets blanked out when editing a qso
wb9kpt wrote:John, you should be able to resolve your issue by adding +01 to +25 to the "reportlistJT.txt" file to accommodate positive signal report values.
Bill WB9KPT
thanks for this info Bill. I have added the lines to the file.
73
John
- G4POP
- Log4OM Alpha Team
- Posts: 10815
- Joined: 21 Jan 2013, 14:55
- Location: Burnham on Crouch, Essex UK
Re: Report Field gets blanked out when editing a qso
Fixed in next maintenance release that we are checking now
73 Terry G4POP