Log4OM

I have noticed that if you edit a JT9 contact that has a plus signal strength report (eg +02) the signal report area (RST sent or RST recvd) gets blanked out. This does not happen if the report is a minus one (eg -02)

perhaps this could be fixed in the next release.


73
John
VK7XX

Yes John that requires attention thank you

John, you should be able to resolve your issue by adding +01 to +25 to the "reportlistJT.txt" file to accommodate positive signal report values.

Bill WB9KPT

It's correct.
the value is blanked because, on load, it doesn't match with allowed RST report values.
Adding the + scale on next release

wb9kpt wrote:John, you should be able to resolve your issue by adding +01 to +25 to the "reportlistJT.txt" file to accommodate positive signal report values.

Bill WB9KPT

thanks for this info Bill. I have added the lines to the file.

73
John

Fixed in next maintenance release that we are checking now