3D2 Conway Reef

[G3ZSS]

When trying to work the recent 3D2CCC operation from Conway Reef I noted an issue with the main QSO window not showing any contacts before with 3D2/c. The following picture shows my 2 contacts with the operation this week.

3D2 F1 Stats.png (44.37 KiB) Viewed 460 times

However if I open the Award Status window you can see that I have already worked 3D2/c on numerous bands

3D2 Award status.png (9.2 KiB) Viewed 460 times

This has only ever happened to me with 3D2/c. All other QSOs with other DXCC entities are showing correctly in the F1 Stats window. I'm using v2.32.1.0

[G4POP]

Hi Peter,
I cant replicate the problem here using a manual entry of 3D2CCC on the same bands and mode, see screenshots below

Have you tried a manual entry instead of the UDP update from WSJT?

Conway two.png (3.19 KiB) Viewed 427 times

Conway one.png (11.6 KiB) Viewed 427 times

[G3ZSS]

Terry, I tried a manual entry for a 10m CW contact but still see the same missing bandslots in the F1 Stats window.

[G4POP]

Hi Peter,
Very odd, I even installed WSJT and tried an FT8 contact via UDP and that worked fine also for same call!

Try 'Rescan Award References from the View/Award status/DXCC award 'Maintenance' tab

[G4POP]

OK so the issue was none of the other 3D2??? QSO’s were with Conway Reef, they were marked as Fiji with a different DXCC ref, see below. Some pre date Log4OM so probably were imported some years ago.

Untitled.png (115.7 KiB) Viewed 385 times

Probably some other QSO's also recorded as Conway Reef which should not be?