Page 1 of 1
Frequency Display
Posted: 24 Apr 2020, 00:11
by N4PYI
How do you get the second frequency display to come alive? Is this for SO2R or am I missing something? Using Flex 6300.
- Log4OMv2 Freq Display.jpg (11.58 KiB) Viewed 5174 times
Re: Frequency Display
Posted: 24 Apr 2020, 00:45
by W2MJP
N4PYI wrote: ↑24 Apr 2020, 00:11
How do you get the second frequency display to come alive? Is this for SO2R or am I missing something? Using Flex 6300.
Log4OMv2 Freq Display.jpg
Seems like a CAT issue. Check your CAT settings. If its installed correct both VFO's should show. I am using Omnirig.
Re: Frequency Display
Posted: 25 Apr 2020, 10:10
by m0pkz
hi,
still no luck with latest log4om second vfo. Here is my setting window.
- Screenshot_1.jpg (155.61 KiB) Viewed 5119 times
Re: Frequency Display
Posted: 30 Apr 2020, 13:24
by W2MJP
I am using Omnirig version 1 not 2. I believe there is a issue with Omnirig V2 and Log4om V2. They don't play nice. If your not already using Omnirig V1 try it. I also don't know anything about the Flex radios. I am using a IC 7610.
Re: Frequency Display
Posted: 30 Apr 2020, 16:39
by G4POP
N4PYI wrote: ↑24 Apr 2020, 00:11
How do you get the second frequency display to come alive? Is this for SO2R or am I missing something? Using Flex 6300.
Log4OMv2 Freq Display.jpg
Not all radio command sets support CAT visualisation of both VFO's
I note that you have been a registered user for some time so you were probably using V1 of Log4OM, did dual VFO display for this radio work with V1?
Re: Frequency Display
Posted: 02 May 2020, 11:23
by N4PYI
Terry,
It did not. And I suspected that it might be "radio related". The Flex radio requires that each com port be set to a slice or VFO.
Thanks!
Re: Frequency Display
Posted: 02 May 2020, 20:03
by KD0ZV
With the Flex, you can add a second rig in OmniRig after setting up another serial port in SmartSDR CAT. You can toggle between those two but I have not been able to get the Flex to work with OmniRig VFO A/B config.
You can also use HamLib instead of omnirig and using Slicemaster the Log4om frequency will change based on active slice.
Rich