Fldigi strangness
Posted: 15 Jul 2015, 18:12
Hello all,
I am new to Log4OM and still learning but I have noticed some strange behavior with the interaction with log4om and Fldigi.
My setup is as follows...
Flex 6500
SmartSDR - Latest version
Flex ComCAT - Latest version
DDutil - v3 (provide multiple comports to access the radio)
Omni-Rig - Latest version
Flidigi - Latest version
Log4OM - Latest version
Everything works fine with no problems except that when Log4om and Fldigi are both running, Log4OM changes the mode in Fldigi from DigiU to SSB. Even after I change it back to DigiU it will change it again. The mode on the radio does not change, just the mode in the drop down in Fldigi.
I thought perhaps it was just something within Fldigi so I started the apps in this order to see what was causing the issue...
ComCat - SmartSDR (in DigiU mode) - DDutil - Omni-Rig - Fldigi. Everything works as explected with or without ddutil or Omni-Rig running. But when Log4OM is run, the mode changes in Fldigi, so it is deffinately Log4OM making the change. I turned off "cat on startup" and the change didn't occur. Anyone else experience this?
Vince N5ATM
I am new to Log4OM and still learning but I have noticed some strange behavior with the interaction with log4om and Fldigi.
My setup is as follows...
Flex 6500
SmartSDR - Latest version
Flex ComCAT - Latest version
DDutil - v3 (provide multiple comports to access the radio)
Omni-Rig - Latest version
Flidigi - Latest version
Log4OM - Latest version
Everything works fine with no problems except that when Log4om and Fldigi are both running, Log4OM changes the mode in Fldigi from DigiU to SSB. Even after I change it back to DigiU it will change it again. The mode on the radio does not change, just the mode in the drop down in Fldigi.
I thought perhaps it was just something within Fldigi so I started the apps in this order to see what was causing the issue...
ComCat - SmartSDR (in DigiU mode) - DDutil - Omni-Rig - Fldigi. Everything works as explected with or without ddutil or Omni-Rig running. But when Log4OM is run, the mode changes in Fldigi, so it is deffinately Log4OM making the change. I turned off "cat on startup" and the change didn't occur. Anyone else experience this?
Vince N5ATM