Using Omnirig with Log4OM/BandMaster and HB9HQX
Posted: 18 Jan 2016, 23:56
Hi, does anyone have this combo working? I have the latest version of Omnirig and IC-7600v2 ini. I'm also using VSPE - more on that later.
Log4OM and BandMaster work fine with Omnirig. However, if I then try to add HB9HQX using Omnirig nothing happens - the HB9HQX program times out and gives up. There is a cryptic note in the HB9HQX First Steps document: "OmniRig must be installed and configured but not running. "
If I start HB9HQX first and select Omnirig, HB9HQX works, but if I then start Log4OM/Bandmaster, I get the Omnirig configuration screen (twice) and nothing happens. No frequency display on Log4OM and BandMaster reports: "Omni-Rig is not installed".
I am able to run everything at once using DXLabs CI-V Commander (using VSPE) to control HB9HQX, but I would like to simplify the software environment...
Bill - WB9KPT
Log4OM and BandMaster work fine with Omnirig. However, if I then try to add HB9HQX using Omnirig nothing happens - the HB9HQX program times out and gives up. There is a cryptic note in the HB9HQX First Steps document: "OmniRig must be installed and configured but not running. "
If I start HB9HQX first and select Omnirig, HB9HQX works, but if I then start Log4OM/Bandmaster, I get the Omnirig configuration screen (twice) and nothing happens. No frequency display on Log4OM and BandMaster reports: "Omni-Rig is not installed".
I am able to run everything at once using DXLabs CI-V Commander (using VSPE) to control HB9HQX, but I would like to simplify the software environment...
Bill - WB9KPT