Log4OM

Hi all,

Returning to Log4OM again but new to v2. Looks great and looking forward to it. Got a new tower, rotor and beam as well, so some new parts to the station for sure. I have a Ham IV and installed a Rotor-EZ card last night. After some reading, I realized I need PSTRotator to integrate it with Log4OM. Got it installed and working stand alone without issue. But no matter what I try, I can't get it working with the logger. Read the manual, watched YouTube videos (all outdated) that I could find and played with the settings till I'm worn out but No burrito! I'm kinda surprised it's this hard....and I'm an IT guy!

Anyway, are there any videos or actual step by step instructions on pstrotator setup anyone could point me to? Thanks.

Hello try this.

Did you also enable it in the rotator section of program config?

I set up the same system plus Stepir for a friend in the US on Sunday and it worked flawlessly

I've had the same problem....see the other post I just made on this topic. Can't get Log4OM to communicate with rotor controller via PSTRotator.

Rick, W2JAZ