One thing I've noticed is there doesn't seem to be a easy way to edit a single line in a parameter filter. Let's say for example we have a filter with the following parameters:
log.state = WA
log.mode = CW
log.band = 40M
And it gives me a list of stations I desire. Now what if I wanted to perform the same search on OR (Oregon). I bring up the filters window again, all the parameters are still there, but there is no way that I'm aware of just to change the state. I can deselect log.state = WA and create a new parameter, but I think an easier way is that if you highlight one of the lines, it puts the query parameters up above where you created it in the first place where it says: State : Equal: WA. Then you could just change the input to OR and there you have your modified query.
John K7KB
Filter Editing
Re: Filter Editing
Hello John,
Excellent idea
I do agree with you, very, very and again...very usefull.
Excellent idea
I do agree with you, very, very and again...very usefull.
73 Manuel Fernando CT1BXX
Re: Filter Editing
Hello John,
I agree completely. I just created a group of filters to find all QSOs in the years 2011, 2012, 2013....2020. It would have been much easier if I could have simply edited the years before saving each one in this two line filter.
Ted
K2GAV
I agree completely. I just created a group of filters to find all QSOs in the years 2011, 2012, 2013....2020. It would have been much easier if I could have simply edited the years before saving each one in this two line filter.
Ted
K2GAV
Best wishes,
Ted Szypulski
K2GAV
Kenwood TS-990, Elecraft KPA-1500
Ted Szypulski
K2GAV
Kenwood TS-990, Elecraft KPA-1500