I have an IC-9700 and an Az/El rotator.
Are there any options to get BOTH the uplink and downlink frequencies?
Is it possible to just GET Az/El rotator angles?
very general questions, so I'm looking for experiences and options.
thanks in advance.
b
Two Sat Ops question
Re: Two Sat Ops question
Version 2.23.0.0
- G4POP
- Log4OM Alpha Team
- Posts: 10807
- Joined: 21 Jan 2013, 14:55
- Location: Burnham on Crouch, Essex UK
Re: Two Sat Ops question
Moved this thread to version 2 forums where you will get more response, no one looks at v1 forum because V1 has been obsolete for a couple of years
73 Terry G4POP
Re: Two Sat Ops question
ahh, yah, I see where I made the mistake. Thanks for taking care of it.
Re: Two Sat Ops question
Hi KA7KDX,
I am using the IC-9700 in SAT mode. And I couldn't find the correct settings for the CAT Interface. I didn't see any frequency but the mode only.
Then I modified the OmniRig ini file so that I get the frequency of the main band now.
Can you tell me your settings for the IC-9700 in SAT mode?
I am using the IC-9700 in SAT mode. And I couldn't find the correct settings for the CAT Interface. I didn't see any frequency but the mode only.
Then I modified the OmniRig ini file so that I get the frequency of the main band now.
Can you tell me your settings for the IC-9700 in SAT mode?
73
Wolf, DL6JZ
Wolf, DL6JZ