Mode Change from Cluster

[N6RSH]

HI,

I tried to search the forum for this topic, but it keeps telling me my search word is too common. Oh well.

Log4OM has been working fine for a few years and suddenly THIS happens: Whenever I select (double click on) a station I want to work from the cluster, and they are listed as "DIGITAL", the program properly switches to the frequency, but it puts my IC-7300 into RTTY-R instead of USB-DATA. Also if the station is listed as "PHONE" it switches me to the freq, puts me in the proper mode (USB/LSB (so far so good)) but changes my IF filter to "FILter 2".

I haven't changed anything (as far as I know). Since this is a new computer, I have been getting all of my programs to work as they did on the old one. I was working on FLDigi the other day, but it had nothing to do with Log4OM. I don't use FLDigi with Log4OM other than sending qso data over, but I haven't made a QSO with FLDigi since I got the new computer.

Thanks for any help es 73,
Steve - N6RSH

[G4POP]

Log4OM version number?

Omnirig or Hamlib and what version numbers?

USB cable connection or Remote on back of rig?

[N6RSH]

Omnirig Version 1.2
Both cables from radio to computer (USB and CI-V)
Thanks,
Steve

[G4POP]

Try changing the setting in the log4om config/CAT menu

[N6RSH]

I have hopefully attached a screen shot of the CAT Management tab in Configurations. Which setting should I change?

[G4POP]

Switch to digital mode......

[N6RSH]

It says "Switch to Digital" already. What am I missing?
Here is my Omnirig panel. I WAS using Hamlib on the old computer. I started using Omnirig on THIS computer a couple of months ago. I was working fine until one day rescently. I just turned on the computer and this started happening. I mean I can manually switch the mode back to USB-DATA but selecting a station in the cluster should put me in the proper mode. I DOES for any other mode except FT8/4.
1) Is there a setting in the Cluster that needs to be changed?
2) Is there a .ini or registry file that needs to be checked?
3) Would it be better to use Hamlib?
4) Do I ask too many question for a guy from Nebraska?

Thanks,
Steve N6RSH

[G4POP]

Try changing the setting that I referred to from FT8 to something else!

[KI5IO]

Steve,

You might could also try the IC-7300-DATA ini from the Omni-Rig Settings.

They provide the different ini's due to programming options from what I've seen.

[N6RSH]

Thanks, Nolan

That did the trick. Changing to IC-7300-DATA works. I can now go to ANY mode from the cluster now. I don't know how it changed, but I am getting old and probably don't remember if/when I did it.

Thanks to ALL who chimed in.

73,
Steve N6RSH