Minor problem with v1.22.0.0

[G4DUL]

Strangely perhaps these days but I still log all my QSOs, even those via repeaters.

When I log a QSO through a repeater, after the QSO I edit (Update the QSO) the entry and I remove the Grid Square entry[1], set the QSL options to I (ignore) and set Distance, Antenna azimuth and Antenna elevation to 0 (zero).

After a Save and Exit, I note that the Grid Square reverts back to its initial setting (it didn't revert back with v1.21) but all the other settings have been saved.
I see that the software is now checking for a VALID Grid Square, but when I am working a /M station there is no valid Grid Square (as they are moving).

There is a work-a-round: I use QSO Manager to update the Grid Square, but that is a bit of a long winded way of doing it. It would be good if you could allow a blank Grid Square when editing a QSO entry.

[1] If I remember during the QSO to remove the Grid Square entry then at the end of the QSO that entry is left blank, even if I then update the QSO.

Thanks for providing Log4OM.

73 Martin, G4DUL

[IW3HMH]

Hi Martin, thanks for reporting, it's probably a side effect of latest changes.
Noted for fix