Log4OM

UPDATE: Just reset everything except the CIV address which I have left at 80h and everything is working ok with Omnirig set for IC7410.
73 de Ron.

Hi Guys

I have my IC-7300 configured and working as Rig 1 but I'm unable to get my IC7100 to connect as Rig 2. I have followed the post and tried without success, does anyone have a list of Connector settings in the IC-7100?

Cheers

Bill G4CFP

1. Make sure that you have the latest version of Omnirig its V 1.16 and download and install the latest rig .ini files because the Omnirig install does not include the latest versions
2. Make sure you installed Omnirig to 'Run as an administrator'
3. Make sure that you installed Log4OM to 'Run as an administrator'

I have an IC7600 as rig 1 and IC7100 as rig 2 working 100% OK

My settings are shown beow but your com port and baud rate is probably different

Thanks for the post

I do run both as administrator and have checked my Omni Rig setting and they look ok. I will dig the 7100's manual out and see how I setup the USB Comm's port to match up with the Omni Rig setting

Regards Bill G4CFP

Hi from an embarrassed member

I had the wrong com port selected.

Many thanks Bill G4CFP