Log4OM

Dear Colleagues,
I would like to propose an idea.
Probably some of us has a linear amplifier, and some have a manual tuning.
We have a paper with the values for "Tune" and "Load"
What do you think about the possibility to have it displayed ?
According with the Band / QRG it will show the values for Tune and Load as image I enclose.
The way to enter the values is a kind of table with some values per band, and than depending the qrg value it shows the values for TUNE and LOAD.

I hope I have been clear about the idea.
Thanks for reading.

I use a manual antenna matching unit and the same applies for that, nice idea but perhaps a little smaller ot stacked because the Winkeyer button will be alongside the Rig select drop down

Ok, Terry can you add this one to our Mantis?