New user, error message not connected to any database
Posted: 13 May 2015, 16:09
Hi folks,
I am returning to AR after an 8 year break due to us moving into an area that had severe antenna restrictions. I have finally got permission to put up an antenna, only a vertical for now but I am back on air.
I have installed LOG4OM on my iMac (OS X Yosemite) which I use VMware Fusion to run Windows 7 on. I go through the setup process, and create a database etc, when I attempt to log a worked station I get an error message--
NOT CONNECTED TO ANY DATABASE OR DATABASE ERROR. OPEN OR CREATE A NEW DATABASE.
I have tried several times to create databases, have uninstalled software, reinstalled it again and started over yet I keep running into this error.
Has it come up before and if so is there a known work around?
I very much appreciate any assistance to point me in the right direction.
73 from Perth, Western Australia.
Tim, VK6EI.
I am returning to AR after an 8 year break due to us moving into an area that had severe antenna restrictions. I have finally got permission to put up an antenna, only a vertical for now but I am back on air.
I have installed LOG4OM on my iMac (OS X Yosemite) which I use VMware Fusion to run Windows 7 on. I go through the setup process, and create a database etc, when I attempt to log a worked station I get an error message--
NOT CONNECTED TO ANY DATABASE OR DATABASE ERROR. OPEN OR CREATE A NEW DATABASE.
I have tried several times to create databases, have uninstalled software, reinstalled it again and started over yet I keep running into this error.
Has it come up before and if so is there a known work around?
I very much appreciate any assistance to point me in the right direction.
73 from Perth, Western Australia.
Tim, VK6EI.