Log4OM

I really love the new large VFO display! Thanks.

A minor bug though.

I run FTdx-5000.

When using just VFO A the RX/TX indicators are correct.

When split with just one RX the RX/TX indicators are correct.

But when using both VFO's to receive in split mode (ie., listening to DX on VFO A and the pileup on VFO B) the TX/RX indicators become confused.

Hans
I am looking into this because another user reported something similar with a TS480

Let me get my TS 480 set up to test this

K0HB wrote:But when using both VFO's to receive in split mode (ie., listening to DX on VFO A and the pileup on VFO B) the TX/RX indicators become confused.

Hans,
I need you to explain this because I don't understand what you are trying to describe?

Today I finally got my Kenwood radio on the bench to test split ops and all is working fine as far as I can see except that the RX frequency is not being added to the QSO record

Hi Terry,

I also have a similar problem with the FT-1000 dual VFO display.

Normal operation on VFO A is correct with RX and TX on VFO A

Split operation is correct with RX on VFO A and TX on VFO B

Dual operation is incorrect with RX and TX both displayed on VFO B. It should be displaying RX on both VFO A and B and TX on VFO A.

Dual and split together is also incorrect as it is displaying RX on VFO B and TX on VFO A. It should be displaying RX on VFO A and RX and TX on VFO B

It is no big issue for me but thought I would let you know what it is doing on the FT-1000 dual VFOs.

73 de Steve VK7CW

I think you are refering to using both receivers so RX 1 has VFO A set and RX2 has VFO B set for example?

Yes Terry VFO A is RX1 and VFO B is RX2

Omnirig reports only one VFO as TX and one VFO as RX
I can cheat, of course, but...

Not an urgent issue. I can live with it.