Minor problem with v1.22.0.0
Posted: 28 Jun 2015, 06:47
Strangely perhaps these days but I still log all my QSOs, even those via repeaters.
When I log a QSO through a repeater, after the QSO I edit (Update the QSO) the entry and I remove the Grid Square entry[1], set the QSL options to I (ignore) and set Distance, Antenna azimuth and Antenna elevation to 0 (zero).
After a Save and Exit, I note that the Grid Square reverts back to its initial setting (it didn't revert back with v1.21) but all the other settings have been saved.
I see that the software is now checking for a VALID Grid Square, but when I am working a /M station there is no valid Grid Square (as they are moving).
There is a work-a-round: I use QSO Manager to update the Grid Square, but that is a bit of a long winded way of doing it. It would be good if you could allow a blank Grid Square when editing a QSO entry.
[1] If I remember during the QSO to remove the Grid Square entry then at the end of the QSO that entry is left blank, even if I then update the QSO.
Thanks for providing Log4OM.
73 Martin, G4DUL
When I log a QSO through a repeater, after the QSO I edit (Update the QSO) the entry and I remove the Grid Square entry[1], set the QSL options to I (ignore) and set Distance, Antenna azimuth and Antenna elevation to 0 (zero).
After a Save and Exit, I note that the Grid Square reverts back to its initial setting (it didn't revert back with v1.21) but all the other settings have been saved.
I see that the software is now checking for a VALID Grid Square, but when I am working a /M station there is no valid Grid Square (as they are moving).
There is a work-a-round: I use QSO Manager to update the Grid Square, but that is a bit of a long winded way of doing it. It would be good if you could allow a blank Grid Square when editing a QSO entry.
[1] If I remember during the QSO to remove the Grid Square entry then at the end of the QSO that entry is left blank, even if I then update the QSO.
Thanks for providing Log4OM.
73 Martin, G4DUL