Log4OM

Hello Folks, Do not quite understand how that F10 works. I went to the manual but it did not tell me much.

The situation is that I only see calls on various bands. Most of the time I see nothing, not even my own call and frequency in the center square. Maybe I'm not turning something ON.

The radio responds fine with the right band freq and mode so I know that the CAT is working.

Any ideas?

Andy, W3LI

The square in the centre represents the frequency the radio is tuned to

Squares each side represent adjacent frequencies

If stations are spotted by the cluster on your frequency or the adjacent frequencies their calls are shown in the relevant boxes

Tnx Terry, I thought that it would pick up the freq of my Oll and display it.

Andy, W3LI