Log4OM

I have just got an Icom 7300 to replace my Flex 6300.

I have just been setting up the rig with WSJT-X, which I run with JT-Alert. I have JT-Alert set to load itself, WSJT-X and Log4OM. When I have finished a JT modes session, I close WSJT-X and JT-Alert and then the rig is keyed to TX. The only way I can get out of this is to close Log4OM. Any idea what is causing this. naturally, I would rather Log4OM stay loaded.

Mni tnx es 73 de Guy G4DWV/4X1LT

Log4OM is not aware of JT presence. It provide access to the database but doesn't control your rig when it works in JT mode.
Instead, Log4Om can interact with CAT at the same time of JT.

I think there could be a relation between JT software and Omnirig.
Can you try starting Log4OM without CAT and check if that happens?

73
Daniele

Hi Daniele,

That seems to do the trick, loading without CAT. When loading *with* CAT, the rig keys when Log4OM is loaded on its own. But, don't I need Omnirig running?

Cheers

Guy