Log4OM

I enter my QSOs after the fact, sometimes a week or more later. So I always check the Manual time box and add the date and times of the QSO. However when I look at a previous QSO the end date is always the current date of when I entered the QSO and not the actual date of the QSO.
eg I entered a QSO that took place on 1st Jan on the 25th Feb., the start date is 1st Jan but the end date is 25th Feb.
Is there any way to overcome this without having to go into each QSO after entering it and change the end date?
I have looked through the manual and 14 pages of searching posts, but cannot find anything about this

VK5PL wrote:I enter my QSOs after the fact, sometimes a week or more later. So I always check the Manual time box and add the date and times of the QSO. However when I look at a previous QSO the end date is always the current date of when I entered the QSO and not the actual date of the QSO.
eg I entered a QSO that took place on 1st Jan on the 25th Feb., the start date is 1st Jan but the end date is 25th Feb.

I believe that you have the 'Use Real End Time' box checked in the manual date area, please uncheck it!