Log4OM

I AM IN THE PROCESSING OF CONNECTING A ROTATOR AND MY BEAM TO A NEW COMPUTER CONTROLABLE DCU-3. The system includes USB connector. In reviewing your manual I have no clue as to now to hook this up to your software. Please advise. My computer is a flex 6500.

Thanks
Howard
AH6TX
[email protected]
818-203-5337

Hi Howard, I highly recommend PSTRotator https://www.qsl.net/yo3dmu/index_Page346.htm. Your DCU-3 is supported.
Also Log4OM supports PSTRotator, pls consult the Log4OM Manual for details.


73
Roland

Thanks so much for your input. Just a few questions.
1) PstRotator or PstRotatorAz…. which do you recommend.
2) I noticed in your rotor selections you indicated spid rak 360. not sure what that is. I have a HAM IV ROTATOR.
3) When I select a contact from the Cluster will it rotate the antenna to the information provided within the cluster?

Again thanks for your help.

AH6TX
Howard

Hi Howard,

think the Spid rotator is the one that Roland is using but he has marked the one that you have to setting up
for your controller (DCU2(DCU3).

Hey Howard,

1) PstRotator or PstRotatorAz…. which do you recommend.

PstRotator is for Elevation AND Azimuth , PstRotatorAZ is for Azimuth only.

2) I noticed in your rotor selections you indicated spid rak 360. not sure what that is. I have a HAM IV ROTATOR.

In my Station setup I am using an SPID RAK Rotator http://spid.net.pl/en/591-2/, notice the checkmark on the left.

3) When I select a contact from the Cluster will it rotate the antenna to the information provided within the cluster?

Yes absolutely, that's how I am using it.

73
Roland

Juergen you did it again lol ... look at the time stamp .... nice

I asked: PstRotator or PstRotatorAz…. which do you recommend. Not sure which one to order. What do you recommend.

Thanks
Howard