View Omnirig settings
Posted: 30 Jan 2020, 15:16
Just about ready to move to V2. I want to copy the Omnirig settings from V1, so I know how to set up V2. How can I view the Omnirig setup window from V1?
Page 1 of 1
Re: View Omnirig settings
Posted: 30 Jan 2020, 16:25
Click the CAT icon on top row
Re: View Omnirig settings
Posted: 30 Jan 2020, 17:23
I'm looking in V1, to get the settings that I will apply to V2.
In V1 Settings / Options / Cat & Cluster
In the CaT Software area (top left) I can select Hamlib / OMNIrig / Extrenal
I'm confused - how do I view the settings I'm using with Omnirig? Tried to click on the omnirig.exe file (in windows), but nothing happens. Perhaps, you can't open the file when LOF4OM is in use (which it is)?
In V1 Settings / Options / Cat & Cluster
In the CaT Software area (top left) I can select Hamlib / OMNIrig / Extrenal
I'm confused - how do I view the settings I'm using with Omnirig? Tried to click on the omnirig.exe file (in windows), but nothing happens. Perhaps, you can't open the file when LOF4OM is in use (which it is)?
Re: View Omnirig settings
Posted: 30 Jan 2020, 17:26
Right here
Re: View Omnirig settings
Posted: 30 Jan 2020, 17:27
Cancel that last request - found it on the tool bar.
Sorry for being the daily PIA!
Many thanks
Sorry for being the daily PIA!
Many thanks
Re: View Omnirig settings
Posted: 30 Jan 2020, 17:57
Ok, so I'm late for the posts. 
73, Santiago
73, Santiago
Re: View Omnirig settings
Posted: 30 Jan 2020, 17:59
Santiago you and I seem to run in the same circles 
HF-AUTO going back to Paul?
HF-AUTO going back to Paul?