Page 1 of 1
IC-7600v2 with Omni-Rig
Posted: 05 Feb 2020, 12:07
by F5OWK
Hi,
Omni-Rig (V 1.19) seems seems not to recognize IC-7600v2.
No problem with HRD and, of course, I've tried to use with Omni-Rig the same port and baud rate than HRD !
Of course alos, the IC-7600 driver was installed before connecting the transceiver.
So, I have no more idea
Who can help me ?
Thanks in advance. 73 QRO.
Herve
Re: IC-7600v2 with Omni-Rig
Posted: 05 Feb 2020, 12:38
by G4POP
My 7600 worked fine with Omnirig are you sure the baud rate and com port match and is the Icom C-IV address the default Icom one or did you change it?
Re: IC-7600v2 with Omni-Rig
Posted: 06 Feb 2020, 22:46
by IK0TIX
Herve,
this is my setting for 7610, it's the same of my old 7600:
- Cattura.JPG (31.59 KiB) Viewed 5127 times
Re: IC-7600v2 with Omni-Rig
Posted: 07 Feb 2020, 00:13
by G4POP
But are you sure the radio Baud rate is set to 115200 and that the CAT control is set to either USB or ACC according to what you are using.
Did you set CAT to auto start in Program Configuration/CAT?
Are you certain that no other program is using the com port?
It will be a miss-match or menu setting somewhere because I have two friends using the 7610 and neither have issues with Log4OM V2 using Omnirig
I currently have an IC7300 and a 7100 using Omnirig and previously had the 7600 and all work flawlessly.
Re: IC-7600v2 with Omni-Rig
Posted: 07 Feb 2020, 06:47
by F1SMV
Bonjour
test your connexion in first with commander from dx labs software to see more setup. This soft run very well with all trx. After test omnirig.
73 Eric
ps : i have too icom 7600 which run well with omnirig
Re: IC-7600v2 with Omni-Rig
Posted: 07 Feb 2020, 20:40
by IK0TIX
G4POP wrote: 07 Feb 2020, 00:13
But are you sure the radio Baud rate is set to 115200 and that the CAT control is set to either USB or ACC according to what you are using.
Did you set CAT to auto start in Program Configuration/CAT?
Are you certain that no other program is using the com port?
It will be a miss-match or menu setting somewhere because I have two friends using the 7610 and neither have issues with Log4OM V2 using Omnirig
I currently have an IC7300 and a 7100 using Omnirig and previously had the 7600 and all work flawlessly.
Terry, I have no problems with my 7610. Omnirig and log4om v2 work great for me. Mine was an advice to Eric because for my 7610 (except the baud) I use the same settings that I used for my 7600
