Log4OM

Hello everyone, the question may already have been asked, but I did not find it ...

I drive the CAT from my YAEU FT-1000MP MARK-V via OmniRig v1.19. I'm running Log4OM V.2.8.0.0

This works well for VFO B but but VFO A indicates an erroneous frequency and remains blocked on this frequency.

My settings in Omnirig for RIG 1:
- Rig type: FT-1000MP
- Port Com 6
- Baude rate: 48,000
- Data bits: 8
- Parity: none
- Stop bits: 2
- RTS: High
- DTR: High
- Poll int, ms: 5000
- Timeout, ms: 4000

Any ideas ?
Thank you in advance.
73 F8BJE, Guy

Problem solved : I made a factory reset of the YAESU FT-1000MP MARK-V and now both of the VFO are well drived by Log4OM !