Log4OM

Hello,

Using LOG4ON 2 version 2.8.0.0, I recently had some problems updating individual QSOs that were lacking their Grid number. When I tried to do so, Log4OM 2 sent me the following message in red: < QSO Not Saved. Check Band/Mode/Callsign/Date >.

This happened suddenly after about 2000 QSO entered and modified without any problem. The only thing that I did wich was new with WSJT-X was that I recently modified it to use five frequencies on the 60 meters bands for the FT8 protocol.

Is it possible that the fact that I programed more than one frequency for a specific band and mode would generate this error message ? Please note that this error message only appeared for 60 meters QSOs.

If so, how can I correct the database so that I can save the QSO correctly ?

I'm operating a Windows 7 computer with WSJT-X v. 2.2.2 and GridTracker Version 1.20.0906.

Thank you for your help,

Roger
VE2ESF

There are variations of bandplan for every country in an IARU region and we dont have the time or the data to edit a bandplan for each country in the world!

You can to edit the bandplan for your country which is currently stored in the C:\Users\YOUR USER NAME\AppData\Roaming\Log4OM2\bandplan folder as bandplan_r2.xml.

If when you have edited it and tested it to work OK save it with your country DXCC as part of the name, like bandplan_dxcc_001.xml

Please send a copy to me by email and I will add it as a default to the installation package.

Take a look at the bandplan_dxcc_223.xml bandplan to see how I did it for our region.