Callsign lookup in Log4OM with Fldigi not working
Posted: 18 Dec 2020, 19:25
Hi,
I have a new config setup for non FT-8 modes via Fldigi.
I have connected Win4Icom, Log4OM and Fldigi via com0com ports and virtual TXs in Win4Icom - all synchronizing perfect. Fldigi works with rigcat an IC7300 xml file. I can change mode and frequency in all three programs.
The connection between fldigi and Log4OM for the part of logging QSO´s is configured as in the manual and it also works without problems, after I save a log in fldigi it appears in Log4OM.
The only missing link is, that Log4OM does not get the callsign from fldigi for a lookup. In the realtime log viewer I see a lot of fldigi commands for band and mode change, but no entry for a callsign lookup.
Where is the missing link - any ideas?
vy 73 Thomas DG6UAX
I have a new config setup for non FT-8 modes via Fldigi.
I have connected Win4Icom, Log4OM and Fldigi via com0com ports and virtual TXs in Win4Icom - all synchronizing perfect. Fldigi works with rigcat an IC7300 xml file. I can change mode and frequency in all three programs.
The connection between fldigi and Log4OM for the part of logging QSO´s is configured as in the manual and it also works without problems, after I save a log in fldigi it appears in Log4OM.
The only missing link is, that Log4OM does not get the callsign from fldigi for a lookup. In the realtime log viewer I see a lot of fldigi commands for band and mode change, but no entry for a callsign lookup.
- fldigi1.PNG (117.71 KiB) Viewed 8430 times
vy 73 Thomas DG6UAX