Sending Call from FLDigi to Log4OM
Posted: 27 Jan 2021, 09:51
Hi,
Lately I've been paying a little more attention to PSK31 with FLdigi, because it is more interactive than FT8. I realized that despite the qso being recorded correctly there is something that is needed and it becomes very necessary: know if a certain station had been worked before, avoiding to repeat.
Log4OM could help, we only need that FLDIGI sends the call to the QSO input area in Log4OM, as with JTDX or WSJT.
Having the call in the QSO input area, we will see if this station is a "Worked Before”.
In short: when in FLDigi, we click on a call, the call is sent to Log4Om.
As we see in manual, it is not possible to send frequency and mode from FLDigi to Log4OM , it is not important, however having the call in the QSO input area, that’s important for the reason I describe above.
Lately I've been paying a little more attention to PSK31 with FLdigi, because it is more interactive than FT8. I realized that despite the qso being recorded correctly there is something that is needed and it becomes very necessary: know if a certain station had been worked before, avoiding to repeat.
Log4OM could help, we only need that FLDIGI sends the call to the QSO input area in Log4OM, as with JTDX or WSJT.
Having the call in the QSO input area, we will see if this station is a "Worked Before”.
In short: when in FLDigi, we click on a call, the call is sent to Log4Om.
As we see in manual, it is not possible to send frequency and mode from FLDigi to Log4OM , it is not important, however having the call in the QSO input area, that’s important for the reason I describe above.