Page 1 of 1
Click on cluster spot not working with hamlib
Posted: 05 Apr 2021, 18:30
by w9mdb
Clicking on a cluster spot does not set mode or frequency using hamlib.
I don't see any activity in the log file to talk to hamlib at all.
Re: Click on cluster spot not working with hamlib
Posted: 05 Apr 2021, 19:09
by KI5IO
w9mdb wrote: 05 Apr 2021, 18:30
Clicking on a cluster spot does not set mode or frequency using hamlib.
I don't see any activity in the log file to talk to hamlib at all.
Mike,
FWIW - I'm running Hamlib here with my K3. Clicking cluster spot will change freq/mode, but is quite slow and I've tweaked the polling delay time to test as well.
I have my log open and running in Trace mode and (as you noted) there is no comment in the log about the Hamlib action when clicking on a cluster spot.
Re: Click on cluster spot not working with hamlib
Posted: 05 Apr 2021, 19:47
by w9mdb
Was reporting for a friend. Just tested on my system and it's working.
So he must have something set up incorrectly.
Re: Click on cluster spot not working with hamlib
Posted: 05 Apr 2021, 22:38
by w9mdb
Well...it was working and the stopped again...
I see the "Sub" vfo being requested when clicking on a spot (on both PowerSDR selection and on an IC-7300 too).
Neither rig has Main/Sub vfos and I don't see get_vfo_list being called to see the available vfos.
Re: Click on cluster spot not working with hamlib
Posted: 11 Apr 2021, 21:23
by w9mdb
This has been fixed in the latest alpha version.