QSOs on 60M band
Posted: 24 Apr 2021, 15:09
Been doing a lot of QSL work recently, and noticed any time I enter a QSO that is on the 60m band, as soon as the qso opens, it drops the 60m from the drop down for "Band" (which I didnt realize until it had happened first few times) and so when you go to QSL info, change the status over there, and click "Save and exit" get the warning about "QSO Not Saved, check band/mode/callsign..." obviously going back and on QSO page, the band is missing of course.
This happened on 2.9 and I thought maybe it was updated so I updated to 2.13 but the behavior is still there. Doesn't matter if its an untouched QSO from original V1 Log_4_OM or one I just opened, corrected, saved, closed, and reopened. Any 60m band QSO drops the 60m immediately on opening.
Tried searching for "60m" but 3 letters isnt enough to search, and "60 meters" basically comes up with every conversation on the forum. So sorry if this is known already.
This happened on 2.9 and I thought maybe it was updated so I updated to 2.13 but the behavior is still there. Doesn't matter if its an untouched QSO from original V1 Log_4_OM or one I just opened, corrected, saved, closed, and reopened. Any 60m band QSO drops the 60m immediately on opening.
Tried searching for "60m" but 3 letters isnt enough to search, and "60 meters" basically comes up with every conversation on the forum. So sorry if this is known already.