Log4OM

################### Problem description ###################
CAT Screen not show freq, I can click on MODE or BAND and see the change on my Yaesu FT 747 GX but can´t see the freq
Log4OM v2 version 2.16.0.0 Portable.
I was able to use another CAT soft made by [email protected] without any problem.

################### Additional info ###################
Omnirig, rigtype FT-747, Port COM2, BaudRate 4800, Data bit8, Parity None, Stop bit 2, RTS High, DTR, LOW, Poll int 200, Timeout 2000

Omnirig version?

Hi G4POP, the Omnirig version is 1.19

Are any other programs running?

Did you install Omnirig and Log4om to run as an administrator?

Hi Terry,

Yes, I've installed Log4OM following the guide and installed Omnirig when was requested during the installation.
No, there is not other program running, even in a fresh refresh of the laptop and only opening Log4OM I've the same behavior.
The Band and Mode buttons are working, I can see the change in the FT but in the frecuency field still say "offLine"

73

Try a factory reset of the radio

Ok, I will try, although I doubt it since with another CAT software designed by a person from Uruguay, I have been able to see the frequency, change it, change the VFOs, bands, modes, in short everything. But I will try.
As soon as I do the test I will comment on the post.