Log4OM

I am in the label management, print section.
After that I did a print I am not able to do a print again, as the log4on says already printed".
In my case I wrongly set the font size (too large) and the print was wrong; the font size can be set only in this menu (I think so)
I had to redo all the process again.

Just press "reset printed status" red basket button to reset printed status, keeping all informations, until you have found the right solution

tnx Daniele, I went to the manual again (RESET printed status) but I did not fully get the effect I was looking for

buona pasquetta

****** Helpful and resolved the issue

Buona Pasquetta anche a te Don ormai è finita...