Since update RXBand and RXFrequency not logged
Posted: 28 Jan 2022, 07:59
Hi.
I did the update to 2.19 on 26th Jan and since doing that my log no longer contains RX Band or RX Frequency data, only zeros. It previously matched the TX frequency automatically and recorded them fine. Is this just an update glitch or op. error or Omnirig not playing now properly with 2.19 issue?
I don't think its op error as my daughters log has also done the same and neither of us changed any settings and Omnirig hasn't been changed from pre update.
If you press split on the rig the RX Freq and RX Band populate as you would expect them to. Turning off split puts the RX and and RXFreq back to zeros.
Not connected to the above directly but I also noticed that Lat and Lon fields of the other station seems not to be logged too, only filled with zeros being recorded in the QSO manager automatically. However, manually highlighting the records in QSO manager then clicking the 'update info' button to get info from external sources that populates the lat and lon field properly. Should this be a automatic?
Any help gratefully received on these issues.
Icom 7300 is the rig.
Thanks for a good product.
I did the update to 2.19 on 26th Jan and since doing that my log no longer contains RX Band or RX Frequency data, only zeros. It previously matched the TX frequency automatically and recorded them fine. Is this just an update glitch or op. error or Omnirig not playing now properly with 2.19 issue?
I don't think its op error as my daughters log has also done the same and neither of us changed any settings and Omnirig hasn't been changed from pre update.
If you press split on the rig the RX Freq and RX Band populate as you would expect them to. Turning off split puts the RX and and RXFreq back to zeros.
Not connected to the above directly but I also noticed that Lat and Lon fields of the other station seems not to be logged too, only filled with zeros being recorded in the QSO manager automatically. However, manually highlighting the records in QSO manager then clicking the 'update info' button to get info from external sources that populates the lat and lon field properly. Should this be a automatic?
Any help gratefully received on these issues.
Icom 7300 is the rig.
Thanks for a good product.