Log4OM

Hello
for the first time I test the CW function and it works well except that when I leave this CW part the port selected for this CW is not saved, a particular manipulation to do or this problem is already known?
thank you for your comments
73

I think the answer is :
After use the Winkeyer must be disconnected by clicking the connect icon again before the Winkeyer window is closed

F6FLU wrote: 09 Feb 2022, 21:59 I think the answer is :
After use the Winkeyer must be disconnected by clicking the connect icon again before the Winkeyer window is closed

Of course otherwise the port is not closed properly

OK Terry

Thanks for this confirmation
73

Dan,

I experience the same process when I use the Elecraft K3 & P3 Utilities. If I forget to close the port and just shut down those Utility APPs the port remains open. Same for when I use the WK3Tools and WK3Demo APPs from the Winkeyer folks.

The process utilized/expected is not unique to L4OM V2.