CAT control via Omnirig (Xiegu G90)
Posted: 06 Apr 2022, 08:44
Hi All,
New ham here looking for the best logging software!
I have a Xiegu G90 which is supported natively by Flrig and uses the Icom-7100 settings with baud rate of 19200 in Omnirig.
Flrig works flawlessly but I am having problems getting Omnirig to work with Log4OM. Both the test clients installed with Omnirig work fine, but I cannot for the life of me get Log4OM to interface with Omnirig for CAT control. I have looked at lots of posts on here and a few people seem to have the same problem but I have not been able to find a solution. I have also watched Terry’s video tutorials which were great.
It’s a pity Log4OM doesn’t work with Flrig out of the box, and Hamlib looks confusing!
Any help would be much appreciated.
Regards,
Simon (M7WWX)
New ham here looking for the best logging software!
I have a Xiegu G90 which is supported natively by Flrig and uses the Icom-7100 settings with baud rate of 19200 in Omnirig.
Flrig works flawlessly but I am having problems getting Omnirig to work with Log4OM. Both the test clients installed with Omnirig work fine, but I cannot for the life of me get Log4OM to interface with Omnirig for CAT control. I have looked at lots of posts on here and a few people seem to have the same problem but I have not been able to find a solution. I have also watched Terry’s video tutorials which were great.
It’s a pity Log4OM doesn’t work with Flrig out of the box, and Hamlib looks confusing!
Any help would be much appreciated.
Regards,
Simon (M7WWX)