Log4OM

Hi,

A month or so back I did a short /P operation, and changed Station Callsign to 4X1ST/P in the settings (operator and owner callsign are blank). After uploading the contacts, I reverted it to 4X1ST.
Now intermittently, the LoTW upload seems to hang/freeze for hours on end, until I cancel it.

When that happens L4OM uploads the 4X1ST QSOs to LoTW as 4X1ST/P (even though that callsign isn't shown in the settings anywhere).

Any ideas what's happening please?

73 Tim
L4OM 2.21.1.0, Win 10

Have you changed also your LotW informations in the setup? Normally you need an extra information for a /P callsign like certificate and station information.

Update TQSL to latest version. From the TQSL release notes:

2.6.1: Fix a major error in handing previously uploaded QSOs that can cause TQSL
to either hang or keep asking how to handle those QSOs.

73, Markus HB9BRJ

DF5WW wrote: ↑23 May 2022, 05:41 Have you changed also your LotW informations in the setup? Normally you need an extra information for a /P callsign like certificate and station information.

No, I didn't change the LoTW config when I did the /P QSOs. Its always set to my "home" location, although I do have a separate certificate for /P. I also have "Send My Station updated data to LOTW" set.

HB9BRJ wrote: ↑23 May 2022, 06:47 Update TQSL to latest version. From the TQSL release notes:

2.6.1: Fix a major error in handing previously uploaded QSOs that can cause TQSL
to either hang or keep asking how to handle those QSOs.

73, Markus HB9BRJ

Thanks. I've updated TQSL now
It seems to have stopped the "hanging".