Page 1 of 1
Mode switches to RTTY when connecting to CAT
Posted: 24 May 2022, 21:31
by W7NJN
I can't really determine an exact pattern, but, when Log4OM is open (v 2.22.0.0) and I go to Connect --> Cat --> Start Cat, the mode goes to RTTY even those my IC-7610 is in USB mode. Trying to figure out what's gong on here, but if I don't remember to adjust it, I keep logging as RTTY.
I'm using Hamlib, and other than that, everything seems to work fine. It's connect via serial, 19200, 1 stop bit, RTS/DTR, and NONE for Data Carrier Detect.
Anyone else seen this?
Re: Mode switches to RTTY when connecting to CAT
Posted: 25 May 2022, 07:22
by G4POP
Please use Omnirig
Re: Mode switches to RTTY when connecting to CAT
Posted: 25 May 2022, 17:23
by W7NJN
Thank you, looks like Omnirig is working better. I was originally having and issue with Omnirig not working with WSJT-X, but I found that if I launch both Log4OM 2 and WSJT-X as administrator, and set WSJT-X to use "Omni Rig 1", I can have both open at the same time. Pretty neat!
Re: Mode switches to RTTY when connecting to CAT
Posted: 25 May 2022, 19:46
by KI5IO
W7NJN wrote: ↑25 May 2022, 17:23
Thank you, looks like Omnirig is working better. I was originally having and issue with Omnirig not working with WSJT-X, but I found that if I launch both Log4OM 2 and WSJT-X as administrator, and set WSJT-X to use "Omni Rig 1", I can have both open at the same time. Pretty neat!
Matt,
That is covered in detail in the extensive User Guide.