Log4OM

I have just updated to v2.23.0.0 and suddenly all the band, mode and frequency details below the Operator Name box are not being filled in; I have to do it manually. The displayed frequencies in the VFOA and VFOB boxes are fine. I have had this problem in the past, but it seems to have been resolved in recent versions.
I think it may be an idea to populate these frequency boxes from the VFOA display. It seems that this data is derived from two different sources at the moment, and one of them is not being read correctly (or at all).
The rig is an ANAN7000 DLE MkII with PowerSDR selected in Omnirig for data transfer. I am using a Win11 system. Any help for what to look at in the config would be welcome.

73, Richard, G3ZIY.

Did you set both programs to 'Run as an administrator'?

Working fine here with my SunSDR 2 DX and also my Icom 7100

I run Thetis, Omnirig/PowerSDR and Log4OM2 all in admin mode, with the same result.

Try a fresh download and install please

Unfortunately no change after a fresh download and fresh install "run as administrator".